CONTRIBUTORS
Written by Olivier Clarinval
Revised by Nancy Heller
Illustrated by Dan Young
Production by Karen Jacobson
Contributions by James Oliver, Ron Naminski, William Menezes, Charles Skandalis, David Alexander, Vince Duperron, German Rico, Hao Pham, Matt Law, Cherry Nuque, Lyle Stoll, Samuel West, John Kelly, Jim Passint, Keith Schilling, David Diederichs.
Cover Design by Sarah Bolles, Sarah Bolles Design, and Dany Galgani, SGI Technical Publications
COPYRIGHT
© 2002 Silicon Graphics, Inc. All rights reserved; provided portions may be copyright in third parties, as indicated elsewhere herein. No permission is granted to copy, distribute, or create derivative works from the contents of this electronic documentation in any manner, in whole or in part, without the prior written permission of Silicon Graphics, Inc.
LIMITED RIGHTS LEGEND
The electronic (software) version of this document was developed at private expense; if acquired under an agreement with the USA government or any contractor thereto, it is acquired as “commercial computer software” subject to the provisions of its applicable license agreement, as specified in (a) 48 CFR 12.212 of the FAR; or, if acquired for Department of Defense units, (b) 48 CFR 227-7202 of the DoD FAR Supplement; or sections succeeding thereto. Contractor/manufacturer is Silicon Graphics, Inc., 1600 Amphitheatre Pkwy 2E, Mountain View, CA 94043-1351.
TRADEMARKS AND ATTRIBUTIONS
Silicon Graphics, SGI, the SGI logo, InfiniteReality, IRIX, Octane, Onyx2, and Origin are registered trademarks, and IRIS InSight, NUMAflex, NUMAlink, SGIconsole, Supportfolio, and XIO are trademarks of Silicon Graphics, Inc.
MIPS is a registered trademark of MIPS Technologies, Inc. used under license by Silicon Graphics, Inc.
Linux is a registered trademark of Linus Torvalds.
| Revision 001 | August 2001 | ||
| Initial Revision | |||
| Revision 002 | April 2002 | ||
| This revision includes the following changes: - Changed the size of the rear mounting bracket from 6 inches to 2 inches. - Changed the number of required mounting-bracket screws from 4 screws to 2 screws. - Indicated that you no longer have to remove the chassis rail from the server when you install or remove a full-height PCI card in PCI slot 2. - Indicated that you must remove the hinged cover from the server when you install or remove a customer-replaceable unit. - Updated the power-on and power-off procedures. - Updated the instructions that describe how to install a server in an SGI rack. - Added connector pinouts. - Removed the appendix that contained L1 controller information. - Added references to the SGI L1 and L2 Controller Software User's Guide. | |||