Search results

...ed socket 370 processors, and conventional SDRAM. The 550 used Slot 2 Xeon processors, the Intel 840 chipset, and RDRAM. The video cards these systems used are ...

...ns are notable for their use of the Intel Pentium II and Intel Pentium III processors (rather than the 64-bit MIPS RISC architecture usually used in SGI compute ...can take 3 3.3V PCI expansion cards. Architecturally, the COBALT graphics processor is related to the MIPS-powered [[O2]] system. ...

...ns are notable for their use of the Intel Pentium II and Intel Pentium III processors (rather than the 64-bit MIPS RISC architecture usually used in SGI compute ...can take 3 3.3V PCI expansion cards. Architecturally, the COBALT graphics processor is related to the MIPS-powered [[O2]] system. ...

...ter poor sales and the limited performance of the first-generation Itanium processors it used became apparent, it was discontinued early, leaving SGI without an ...red one or two first-generation Intel Itanium ''Merced'' processors on its processor board, up to 4GB of PC100 SDRAM on two removable Memory Expansion Cards (ME ...

* Payment Processors? ...

...s the microcode for the Reality Display Processor (RDP) and Reality Signal Processor (RSP) chips. ...

...processors and runs RHEL or SLES Linux. The Altix 330 implements the IP5X processor, but follows the IP41 architecture from the earlier Altix 3000 systems. ...date one or two Itanium 2 processors of the same type. However the 1.3 GHz processors were only offered in a single module, standalone configuration. ...

The PowerSeries systems are the first multiprocessor computers made by Silicon Graphics and were typically shipped in a single o ...s each processor with it's associated cache. The Sync Bus synchronizes the processors of the system and thus helps in parallel processing of data/programs. MPLi ...

...veloped by HPE and Intel in the 1990s to serve as a high end, 64-bit, RISC processor architecture to replace HP's PA-RISC. Incidentally, SGI also adopted it to ...gher stepping of Poulson, called Kittson, shipped and was the last Itanium processor type. All units were shipped by mid-2019. ...

...ared to the Indy. Inside the hardware is nearly identical: power supplies; processor modules; hard disks; memory; and GIO32 cards are all interchangeable betwee The processors are supplied on the same processor modules used on the Indy and are otherwise identical. ...

...e. Near the end of its lifetime, the C-Brick was updated with 800 MHz MIPS processors. ...sed the IP53 motherboard that supported 500 MHz R14000 and 600 MHz R14000A processors with 8 MB secondary caches, later upgraded to use the R16000 and R16000A. ...

...released in 1992. It was the first SGI workstation released with a 64-bit processor. * One superpipelined MIPS 100 MHz R4000 or 150 MHz R4400 processor. ...

|Processor ...dditional directory memory is required in configurations with more than 32 processors. The additional directory memory is contained on proprietary DIMMs that ar ...

...ure from the earlier Altix 3000 systems. A system can include from 1 to 32 processors in up to 16 modules or bricks, with one or two NUMAlink routers connecting ...ency switched fabric computer bus used as a shared memory computer cluster processor interconnection in Silicon Graphics computer systems. The Altix 350 leverag ...

...SMP-capable (dual CPU) machine running the MIPS R10000 to R14000 series of processors. The main differences between the Octane2 and the Octane are configuration ...-bow) that connects any two of its ports. One of the ports is used for the processor and memory subsystem, one is available for PCI (actually PCI-64) expansion ...

...imilar to IRIX 5.2. Later 6.x releases supported other members of the MIPS processor family in 64-bit mode. IRIX 6.3 was released for the SGI O2 workstation onl ...leader in Symmetric Multiprocessing, scalable from 1 to greater than 1024 processors with a single system image made possible by its use of Cray/NUMALinking, a ...

...he [[Origin 300]] model that preceded it. The 350 was offered in two to 32 processor configurations, at speeds ranging from 600 to 1,000MHz over the lifetime of ...standard 2U Origin 350 chassis with four PCI-X and one XIO-2 slot without processor, memory or Bedrock ASIC. Because the 2UPX does not have a BedRock ASIC, it ...

The processors are supplied on a "Processor Module" board with or without external cache (Primary Cache means no extern Indy's motherboard has a socket for the Processor Module (PM). Early Indys used the 100 MHz MIPS R4000 CPU, which quickly pro ...

|Processor ...RM8-16 or RM8-64 Raster Manager boards. The GE14-2 has two Geometry Engine Processors, instead of four like the other models. The RM8-16 and RM864 has 16 or 64 ...

...ld by Silicon Graphics from 2001 to 2004. The 300 was offered in two to 32 processor configurations, at speeds ranging from 400 to 600MHz over the lifetime of t On introduction SGI claimed an industry-leading 3.2 GByte-per-second processor to memory bandwidth, and half that to the graphics subsystem. The DIMMS use ...